It can measure the liquid level and material level, and can meet the measurement requirements of different temperatures, pressures, and media.
It is not affected by the sensor hanging material and does not need to be cleaned regularly to avoid wrong measurement.
There are no moving parts in the measurement process, and there is no problem with damage to mechanical parts.
No maintenance, intelligent adjustment-free.
Contact measurement, strong anti-interference ability, can overcome the influence of steam, foam and stirring on the measurement.
The measurement quantity is diversified, which makes the measurement more accurate, the measurement is not affected by environmental changes, and the stability is high.
Reliable product performance and long service life.
FEEJOY can supply OEM service for RF admittance level switch among all level switches manufacturers, which include material, working pressure, output, etc.
We can manufacture according to customer's specification kike below:
Product Name | radio frequency admittance fuel level controller |
Wetted part Material | SUS304 and SUS 316L |
HS Code | 9032899090 |
Working Pressure | Max 3.0 MPa |
Process temperature | Max 800 deg c |
Output | DPDT relay(double-pole double-throw) |
Contact Capacity | 220VAC, 5A-no sense, 3A-sense |
Response Time | 0.2 S(standard) |
Delay Time | 0.2~90(adjustable) |
Explosion-proof Grade | Explosion-proof: dIIBT4~T6 |
Process connection | thread/ flange, etc |
Conductive and insulating liquids: Chemical industry, oil field, water and sewage treatment
Conductive and insulating paste: Paper, pharmaceutical, water and sewage treatment
Powder: Ash, powder, Power plant, metallurgy, cement
Particles: coal, grain power, plant, metallurgy, grain
Interface: two different liquids, oil field, chemical industry
The RF admittance level switch is the RF admittance level meter, and the potentiometer W1 of the radio frequency admittance level meter is a sensitivity adjustment potentiometer: the LED two-color display lamp lights in green when there is no material, and the red light when there is one. After the meter is powered on, the green light is on when the level is lower than the set value.
At this time, slowly adjust the potentiometer W1 clockwise until the red light is on, and then adjust it 3 times counterclockwise (0.5 to 3 times for non-conductive materials, conductive material 5 ~ 7 circles) and the green light is on (the status of the output relay's contacts should change with the change of the traffic light display state). According to the measurement part of different RF admittance level transmitters, it should be covered by materials at about 75mm.
RF admittance level switch compared to capacitance level switch adopts more advanced RF admittance technology instead of capacitance measurement, which solves the problem of material adhesion.
Compared with other similar products, it has higher stability of the system, and even in extreme conditions it also can work reliably at the scene.